Sample and Hold

From MMM Wiki

Jump to: navigation, search

Sample & Hold

Sample and Hold Basic Operations Video

Internal Triangle LFO for sample source. Can be replaced by inputting an external source into the Ext. Osc. In jack.

Internal square wave LFO for sample rate selection. Can be replaced by inputting an external trigger source into the Ext. Clk. In jack. Source is sampled on the negative to positive transition of the clock.

Image:MMM_Sample_and_Hold.JPG

Pseudo Random output


Track & Hold / Sample & Hold select switch. Bypasses the internal sample strobe in Track position and allows the source to go directly to the output during the lower clock level. When the clock transitions to a high level, the source voltage present at the time of positive clock transition is "held" at the output until the clock transitions low again.

Image:MMM_Track_and_Hold.JPG

Track and Hold output



Slide allows for a slew or glide to be added between output transition voltages.

Image:MMM_Sample_and_Hold_w_lag.JPG

Slide adds transition glide to output

Clock out allows for the sample clock to be used as a timing sync source to other modules. If an external clock source is present at the Ext Clk in jack, the external clock signal is buffered and present at this jack.


Availability

This module is currently available. $195.00


Assembled/ tested board only: $89.00

Info

Current draw:

V+= 12.5mA

V-= 11.70mA

PCB board dimensions:

3.125" (3-1/8") 79.38mm X 2.625" (2-5/8") 66.68mm

Mounting holes: 0.125" (1/8") 3.18mm (for 4-40 screw) 4 holes, one in each corner

Mounting hole spacing; Length: C-C= 2.925" 74.3mm, Width: C-C= 2.425" 61.6mm

Personal tools