5U VC Mixer Kit: Difference between revisions
| (4 intermediate revisions by the same user not shown) | |||
| Line 27: | Line 27: | ||
'''You supply:''' Power cable (see MMM store for power cable selection) | '''You supply:''' | ||
Power cable (see MMM store for power cable selection). Choices are: Standard 4-pin to 4-pin or 6-pin to 6-pin, 12" length. | |||
Knobs-of-choice. | |||
==Features== | ==Features== | ||
| Line 55: | Line 59: | ||
''(Order from either Mattson Mini Modular or Bridechamber!)'' | ''(Order from either Mattson Mini Modular or Bridechamber!)'' | ||
'''$ | '''$180.00''' | ||
To order, visit the [http://www.mattsonminimodular.com/ | To order, visit the [http://www.mattsonminimodular.com/shop MMM Store] | ||
or | or | ||
[http://www.bridechamber.com Bridechamber] | [http://www.bridechamber.com Bridechamber] | ||
Latest revision as of 16:58, 7 June 2014
Combined complete Mattson/Bridechamber VC Mixer kit in 5U format
Contents:
The Mattson parts:
Quantity=1: MMM assembled/tested VC Mixer board
Quantity=1: WK-14B Wire kit
The Bridechamber parts:
Quantity=1: 5U Bridechamber face VCM panel
Quantity=1: 3-hole mounting bracket
Quantity=4: B100K poentiometers
Quantity=4: 0.187x4-40 hex standoffs
Quantity=4: 4-40x1/4" screws
Quantity=10: 1/4" I/O switched jacks
You supply:
Power cable (see MMM store for power cable selection). Choices are: Standard 4-pin to 4-pin or 6-pin to 6-pin, 12" length.
Knobs-of-choice.
Features
The VC Mixer consists of 4 channels.
Each channel has an associated gain control and control voltage input.
There are two outputs; Normal and inverted.
The control inputs respond to a 0-5V control voltage input. 0V is fully attenuated and 5V will produce a 100% output level.
The Level control attenuates the channel level.
The control inputs are cascaded. 5V is applied internally to the Control input for the channels and cascaded from channel 1 to channel 4. This allows the module to be used as a 4-channel mixer with no control voltage input to the Control in jacks.
When a Control input is plugged into a channel Control in jack, it interrupts the 5V from that channel through channel 4 allowing the gain for that channel, and all subsequent channels to be controlled by the new control voltage. New control voltages applied to the subsequent channels will interrupt the preceding channel control voltage for that channel and be applied to the remaining channels.
The trim pots on the circuit board are labeled with the associated CV gain adjustment and are set for a 1:1 input to output ratio. They can be trimmed to provide additional gain to utilize the mixer as an amplifier, if so desired. The gain will clip the original signal and can be set to overdrive the signal into a square wave peaking at the positive and negative power supply levels.
The mixer will work with both audio and CV inputs.
Availability
This kit is available: (Order from either Mattson Mini Modular or Bridechamber!)
$180.00
To order, visit the MMM Store or Bridechamber
Go to board dimensions and mounting
